手机版|
二维码|
1．Download：
【Software】 【64Driver】 【Manual】 【Firmware】 【SDK】
2．Accessories：
3.Other Pictures
Connected to the computer can be used as a virtual oscilloscope
4. Characteristic（Handheld Oscilloscope/Multimeter）
全隔离手持示波表，示波器通道间完全隔离，示波器和万用表通道隔离，示波器、万用表与USB等通讯接口之间完全隔离，隔离等级:1000V CATII,600V CATIII.
High Bandwidth 60MHz-200MHz Oscilloscope,1GS/s sample rate, and 6000 Counts DMM with analog bargraph , and data recorder.
2M Memory Depth.
High Refresh Rate （2500 frames）
Large 5.6 inch TFT Color LCD Display，High Resolution（640*480）, Dual-Window Design --More clear, More Detailed
One-touch automatic setup optimizes the position, range, timebase, and triggering to assure a stable display of virtually any waveform
Easy-to-use pop-up menu with built-in multi-language help system
23 Automatic Measurements
Waveform Math: Add, Subtract, Multiply, and Divide
Store and recall over
Automatic cursor tracking measurements
XY Mode
Built-in FFT function converts a time-domain signal into its frequency components to measure harmonic content and distortion in systems
Waveform Recorder to capture/replay input waveforms from CH1 and CH2 with a maximum record length of 1000 frames
Pass-Fail function compares a stored waveform to an unknown input
Average Mode for smoothing waveforms
Square Wave Output （2V, 1kHz） for probe adjustment
USB Host/Device 2.0 full-speed interface ,support removeable disk, LAN Optional ,Easy to control by PC or long-distance.
Dimensions （mm）:240（L）x165（W）x50（H）, be carried easily.
LabviewVBVC Second Design instance.
5. Hardware Specification
Model
DSO1202S
DSO1122S
DSO1062S
Oscilloscope mode
Bandwidth
200MHz
120MHz
60MHz
Real-time Sample Rate
1GSa/s
Equivalent Sample Rate
25GSa/s
SEC/DIV Range
2nS/div-2000S/div （in a 2, 4, 8 sequence）
Delay Time Accuracy
500ps
Vertical
A/D Converter
8-bit resolution
VOLTS/DIV Range
2mV/div～5V/div at input BNC
Position Range
50V（5V/div）, 40V（2V/div～500mV/div）, 2V（200mV/div～50mV/div） 400mV（20mV/div～2mV/div）
Record Length
Single-channel: Maximum 2M; Dual-channel:Maximum 1M
Trigger
Trigger Sensitivity
（Edge Trigger Type）
DC: CH1/CH2（Typical） 1div from DC to 10MHz;1.5div from 10MHz to Full
AC: Attenuates signals below 10Hz
HF Reject: Attenuates signals above 80kHz
LF Reject: Attenuates signals below 150kHz
Noise Reject: Reduces trigger sensitivity
Trigger Level Range
CH1,CH2: 8 divisions from center of screen
Trigger Level Accuracy,
typical （Accuracy is for signals having rise and fall times 20ns）
CH1,CH2: （0.3div V/div） （within 4 divisions from center of screen）
Holdoff Range
100ns-10s
Trigger Type
Edge
Trigger on the rising or falling edge
Pulse Width
Trigger （when , ,=, ） on positive or negative pulses
Pulse Width Range: 20ns-10s
Video
Trigger on an NTSC, PAL, or SECAM standard video signal
Line Range: 1-525 （NTSC）, 1-625 （PAL/SECAM）
Slope
Trigger （when , ,=, ） on a positive or negative slope
Set Time: 20ns 10s
Overtime
from the rising or falling edge
Set Time: 20ns-10s
Alternate
Internal trigger on edge, pulse width, video or slope
Measurement
Cursors
Manual: The difference between voltage cursors △V; the difference between time cursors △T; 1/△T calculated by Hz.
Tracing: The voltage and time at a waveform point
Automatic
Pk-Pk, Max, Min, Mean, Cyc RMS, Frequency, Period, Rise Time, Fall Time, Positive Width, Negative Width
Meter Mode
Max.Resolution
6,000 Counts
DMM Testing Modes
Voltage, Current, Resistance, Capacitance,Diode Continuity
Max. Input Voltage
AC: 600V, DC: 800V
Max. Input Current
AC: 10A, DC: 10A
Input Impedance
10 M
Isolation
The float voltage between BNC and Ground
600V CATIII, 1000V CAT II
The float voltage between each Channel
600V CATIII, 1000V CAT II
The float voltage between Multimeter and Ground
1000V
between input Ports directly
400V CAT II
Input by 10:1 probe
600V CATIII, 1000V CAT II
The Max input voltage of Multimeter
DC 800V,AC 600V
Display
Type
Right angle 5.6 16-digit color LCD
Resolution
640*480 dots
Contrast
16 gears, with the progress bar to show adjustment
Interface
USB host and USB slave, Lan Optional
Power Supply
Voltage
DC Input:12--17VDC, 2000mA
Mechanical
Size
245 x 163 x 52 （mm）
Weight
1.3KG （exclusive of packing and accessories）
6．Software：
Operating system: Windows NT, Windows 2000, Windows XP ,VISTA
7．SecondDesign：
Supply DEMO code （VC、VB、LABVIEW）
以上信息由企业自行提供，信息内容的真实性、准确性和合法性由相关企业负责，91化工仪器网对此不承担任何保证责任。
温馨提示：为规避购买风险，建议您在购买产品前务必确认供应商资质及产品质量。
